Deflation Operation; Special Smart Pressure Monitoring - Seamax SUP20MAX Bedienungsanleitung

Vorschau ausblenden

Inhalt

Inhaltsverzeichnis

Verfügbare Sprachen

▪

During the inflating process, the LCD screen displays the inflatable product's on-going real time air

pressure. The preset target air pressure number will appear in every 3 seconds in flashing mode for the

user's information.

▪

Remove the hose from the inflation port. Connect the end with flexible conduit adaptor (11) of the hose

with the air pump deflation port (2). Twist clockwise to tighten it (Figure 3 – SUP20D). The other end shall

still be to the inflatable product. Please know you should release all the high pressure air before attach

the pump for deflation. Press the On/Off Power Button to start the deflation until all the air inside the

inflatable product is discharged. Turn off the air pump to stop the deflation.

SPECIAL PRESSURE MONITORING FEATURE

This SUP20MAX Air pump is equipped with a special Smart Pressure Monitoring Feature. Once the pressure

reading reaches 0.6 PSI when inflating in the 1

increasement. If the pressure increasement is less than 0.03 PSI in a period of continuous 6 seconds, the internal

controller sees the 1

stage is reaching its max inflation capacity. Then the pump will receive a signal to stop the

stage and start the 2

Based on the new program, this pump can provide the best inflation efficiency for inflatable SUP, boat, kite, tent

and any kinds of inflatable tops provided using a suitable air valve adapter and max 20 PSI pressure requirement

met. It saves user's time and energy to quickly inflate the product to the targeted PSI.

To best utilize this function in the proper way, a good condition qualified power source is necessary to suppor the

pump. During the whole inflation process, users need to make sure the air tightness and minimized air leaking

along the air passage from the pump's inflation port to your inflatable product through the air hose connection.

In case the pump could not automatically switch to the 2

chamber reading pressure can be over 0.6PSI, and you start the pump again to activate the 2

the pump detects over 0.6 PSI pressure when started, it will bypass the 1

high pressure pumping directly.

Tips: if the 1

stage could not start properly in some unsual situation, user can use a manual pump to inflate the

product to about 1 PSI, and then use this pump to do the rest of the inflation proess directly starting from tis 2

stage. When the air pressure is over 5 PSI, the pump will start the monitoring program again. If the pressure

increasement rate start to decrese for a set period of time or the internal tempreture is over 85 Celsius (185

Fahrenheit), the internal protection mode will be activated. The pump will stop automatically to avoid over

heating issue.

8 |

P a g e