Seamax SUP20MAX Bedienungsanleitung Seite 10

You can discuss with us for any other problems. Otherwise if your pump had been checked and no more high
pressure created. we believe your pump had been damaged. Then you get to contact us via email directly for
repair or replacement. You can find our email from Seamax Marine website or the pump user manual. Since
we can't give you our email address from Amazon message. You can forward this message to our customer
service with your original order ID. And you may need to pay for the shipping and handling cost if your
purchase is over 60 days and return the original pump. Thanks again for contact Seamax.
FAULT
The air pump 1. The power source is not
cannot be started plugged properly.
normally. 2. The fuse in DC plug (7) is
burnt out.
3. Overheating or overload.
Slow or abnormal 1. Check whether the hose is
inflation. blocked or cracked.
2. The joint between the
Pump stop before hose and air pump or
reach set pressure inflatable product is not
installed properly.
3. Make sure the power
source meets the pump's
requirements 12V 15A
4. Check input voltage, make
sure not voltage low issue
5. Check Temperature
10 | P a g e
INSPECTION
1. Make sure the connect to the 12V DC socket.
2. Change the fuse.
3. Take off the Sand Cap from the pump intake or outtake. Cool
the motor and restart it. Turn on the pump in the air to force it
fast cool down.
1. Change the hose or make it unblocked, and check whether the
hose is cracked.
2. Reinstall the hose or valve adaptor, put the right size O ring
3. If the problem cannot be solved, please contact with the
manufacturer or its service agent or the similar authorized
personnel.
4. Do NOT use compact AC to DC wall convertors to power the
pump. Connect the pump car charger adapter directly to a car's
charger socket. Or use a well charged minimum 12V 7AH external
lead acid battery with the optional 12V battery connector.
5. check the input voltage before the pump stop, make sure the
voltage is within 9-15V. . If the internal tempature too hot, the
pump will stop with its screen showing over-heat.
SOLUTION