Seal The Box - Renson Fixscreen 100 Slim Montageanleitung

Fixscreen
en
13
6 • Seal the box
ø5
Pay attention!
The bottom bar is retractable. So pay attention that the bottom
bar does not hit the fabric on the fabric roller.
34
100 Slim (F)
®
With a single screen or a coupled screen: close the box with
the cover below the box and fix this to the reversed U-brackets
on both sides of the box, by means of the 2 screws near the
supporting endpieces with a torx screwdriver.
- Install the front part of the
side channel and fix it.
- Check if the screen glides
freely and without any
tension in the plastic side
channels.
- During the setting of the
motor you have to set an
end point at the top and
bottom.
Slide the fabric into the
internal HPVC channel.
Be sure to observe the correct
direction of the side channels!
Make sure the V cut-out is
positioned at the top of the
side channel and the clicker
is positioned at the bottom of
the side channel.
In case of a deep side
channel, the front part is
supported by black clips,
applied each 400 mm.
ø5