Controls - PEUGEOT E-vivacity Bedienungsanleitung

J. Traction system diagnostic indicator light
The indicator light comes on when the ignition is turned on
to check it is operational and comes off after 3 seconds
FR
if there are no faults.
If an incident occurs, the driver is informed by the light.
•The light comes on and stays on.
GB
Serious safety fault or fault which could
lead to destruction of the engine, the
vehicle must be stopped.
•The light flashes.
DE
Serious fault affecting the functioning or
riding comfort.
IT
ES
NL
GR
K. Maintenance indicator
The maintenance indicator goes on 5000 kms after the
last reset.
SE
You are advised to go to an authorised dealer to have the
vehicle serviced and the message on the maintenance
indicator erased.
PT
L. Milometer. Tripmeter (TRIP)
The tripmeter displays and stores the number of
kilometres travelled by the vehicle. The machine total
kilometres remains in the memory when the battery is
FI
disconnected.
Each time the contact is made, the instrument panel
automatically displays the odometer mode.
The tripmeter displays and stores the number of
DK
kilometers travelled during a given period.
Changing from the total distance display to the daily
8/14
distance display
• With the ignition on, changeover from the total distance
to the daily distance display and inversely is by briefly
pressing the control button (1).
Resetting the tripmeter
• Multifunction display on.
• Display the daily counter (Trip) with a short press on the
control button (1).
• The daily counter is reset by pressing more than
3 seconds on the control button (1).
M. Setting the clock
• Multifunction display on.
It is only possible to set the time in the total kilometres
position with the machine stationary.
Pressing the control button (1) for more than 3 seconds
will make the two hour digits flash.
• Set the time by successive pushes on the control
button.
Pressing the control button for more than 3 seconds will
make the first digit of the minutes flash.
• Change the minutes by successive pushes on the
control button.
Pressing the control button for more than 3 seconds will
make the second digit of the minutes flash.
• Change the minutes by successive pushes on the
control button.
• Press the control button for more than 2 seconds to
confirm the clock setting.
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Scooters

CONTROLS

3
2
1
1. Horn switch
2. Indicators switch
To indicate a change of direction, press the switch:
• Either to the right.
• Or to the left.
To stop the indicators flashing, press the switch (A).
3. Dipped lights/Headlights switch
The dipped lights/headlights switch has 2 functions:
B. High beam.
C.Dip beam.
4
8
4. Pedestrian warning button/Starter button
This button has 2 functions:
• When the ignition is switched on, pressing this button
will power up the traction system.
• When driving, this is a low power audible signal to warn
pedestrians and cyclists of your approach.
B
C
A