Creating A Raid 1 - Fujitsu Siemens Computers JMicron JMB362 Benutzerhandbuch

Creating a RAID 1

Creating a RAID 1 will cause all data on both hard disks to be deleted!
The system must be rebooted after the RAID has been created.
The "Fujitsu Siemens Computers Recovery solution" provides a means of
restoring factory settings for the software, provided that the data backup
has been carried out prior to setting up the RAID.
The data backup/data recovery procedure for your PC is described in
detail in the "Recovery Process" manual.
RAID 1 means that all data will be copied from the primary hard disk
(source drive to the secondary hard disk (mirror drive). The capacity of the
secondary drive must therefore be the same or larger than the primary drive,
otherwise it will not be possible to create a RAID.
► Select Create RAID Disk Drive using the arrow keys and press the Enter key.
10600854936, edition 1
BIOS Setup Utility
English - 9