Modifying Default Settings - OEG 650 001 127 Montage- Und Bedienungsanleitung

IMPORTANT:
This operation is used to facilitate servicing and future repairs. The default settings
should only be modified by an experienced technician.
The system parameters can be checked and adjusted via controller by the following steps:
Step 1: Hold button until you enter the verification mode for parameter setting.
Step 2: Press several times until you reach the setting parameter to be adjusted.
Step 3: Press button to start the configuration of the setting parameter.
NOTE: Some settings cannot be modified. Consult the settings table for further
information.
Step 4: Press and to adjust the setting value.
Step 5: Press button to set the new value.
Step 6: Press and to return to the main screen.
Step 1
Step 4
Step 4
Swimming pool heat pump
Step 2
Step 5
Step 5
Step 3
Step 6
Step 6
67

Modifying default settings

4.10
GB