Connection Of Condensation Draining Kit; Installation On Vibration- Absorbing Pads; Hydraulic Connection - OEG 650 001 127 Montage- Und Bedienungsanleitung

54
3.4 Connection of condensation
draining kit
3.5 Installation on vibration-
absorbing pads
3.6

Hydraulic connection

GB
While operating, the heat pump is subject to condensation. That will result in a more or
less large run-off of water, depending on the degree of humidity. To channel this flow, we
recommend the installation of a condensation draining kit.
How do you install the condensation draining kit?
Install the heat pump by means of sturdy and moisture-resistant blocks with a clearance
of at least 10 cm. Then connect the included condensation line incl. hose nozzle below the
heat pump to the round aperture in the bottom plate / condensation tray.
See also page 53, 3.3. position condensation draining.
The ½" side port (white plug) is used for draining the water / fluid after a longer standstill
of the heat pump, e.g. before recommissioning in spring.
See also page 54, 3.3 position drain plug.
In order to minimise the noise pollution associated with heat pump vibrations, it can be
positioned on vibration-absorbing pads.
For this, you simply have to position a pad between each of the unit's feet and its support,
and then fix the heat pump to the support with suitable screws.
IMPORTANT:
Installation must be carried out by a qualified technician. This section is provided for
information purposes only and has to be checked and adapted if necessary according
to the actual installation conditions.
By-pass assembly
The heat pump must be connected to the pool by means of a by-pass assembly.
The assembly consists of 3 valves that regulate the flow circulating in the heat pump.
During maintenance operations, the by-pass allows for the heat pump to be isolated from
the system without interrupting the operation of the pool.
Outlet
TOWARDS THE POOL
Inlet
FROM THE POOL
Open valve
Half-open valve
Swimming pool heat pump