Chicco Humi3 Bedienungsanleitung Seite 23

Cold humidifier
3
HUMI
Package contents
Humidifier
AC/DC mains adaptor
Instruction manual
Legend of device components (Fig. A)
1) Led light indicating device is on
2) On (I) off (O) switch
3) Product socket
4) Steam outlet nozzle
5) Water tank
6) Nebuliser unit (transducer)
7) AC/DC mains adaptor
8) Holding points
9) MIN / MAX water level indicator
10) Air vents
Warning!
Always use cold boiled drinking water (left to
cool after boiling to at least 40°C) both to fill
the water tank/reservoir for normal use and to
perform daily and weekly cleaning operations,
as described in the user instructions manual.
This will prevent the proliferation of germs and
bacteria.
INSTRUCTIONS FOR USE
Preliminary operations and operation
• Make sure the device is perfectly clean, that
switch (2) is in the off position (O) and the
AC/DC adaptor plug (7) is not connected to
the mains.
• Lift the nebuliser unit (transducer) (6) using
the holding points (8) (Fig. B).
• Fill the water tank (5) with cold previously
boiled water up to the indicated MAX level
(9) (Fig. C - D).
• Put the nebuliser unit (transducer (6) back on
the water tank (5).
• Place the device in the selected area, at
height of about 70 – 100 cm, following the
indications specified in the "Warnings" sec-
tion.
• Connect the plug of the AC/DC adaptor cord
(7) to the socket (3) on the device (Fig. E),
then connect the AC/DC adaptor plug (7) to
a mains socket.
• Turn on the device by pressing the on switch
(2) - position (I); at this point the blue LED will
go on indicating the device is on (1) (Fig. F)
and steam will start to come out of the steam
outlet nozzle (4).
• The humidifier has a water level sensor. When
the water level in the tank falls below the MIN
level, the nebulisation circuit automatically
goes off (stand-by function) to prevent dam-
age to the transducer.
SAFETY AND MAINTENANCE
Warning!!
Always turn off the device before performing
any cleaning/maintenance operations by us-
ing the on (I) off (O) switch (2) and remove the
AC/DC adaptor plug from the mains socket in
order to prevent a risk of electric shock.
Daily cleaning:
In order to avoid/reduce the formation of bac-
teria or scale residues, it is necessary to clean
the device daily, as indicated below:
• Lift the nebuliser unit (transducer (6) with the
humidifier holding points (8) from the water
tank (5).
• Empty the remaining water from the water
tank (5).
• Fill the water tank (5) with clean, cold boiled
drinking water.
• Rinse several times completely draining the water.
• After removing the water, thoroughly dry
with a dry cloth gently running it over the
nebuliser unit (transducer) (6) as well.
• If the device is not used after the daily clean-
ing procedure, dry all parts immediately and
then store it away.
Warning!!
• Avoid cleaning the water tank (5) with harsh
detergents, abrasive products, alcohol, sol-
vents or similar products: they can damage
the water tank (5).
• Never place the device under running water.
• Never allow the electric cord or air vents to
come into contact with water.
• Do not let water get into the upper part of
the nebuliser unit (transducer) (6); if this
should happen take it to your dealer or a
specialised technician for testing before us-
ing it again.
23