Cleaning And Maintenance; Troubleshooting; Other Errors; Technical Specifications - cecotec bongo S Serie Bedienungsanleitung

ENGLISH

6. CLEANING AND MAINTENANCE

CLEANING:
• Clean the vehicle with a soft cloth, water and soap if necessary.
• After cleaning, dry thoroughly any metal parts subject to corrosion, oxidation, etc.
• Do not use Alcohol, gasoline, kerosene or other corrosive or chemical solvents.
• Do not clean the device with high-pressure water.
• Make sure the charging cable has been pulled out and the rubber cover of the charging
port is tightly fastened, otherwise electric shock or serious failure may occur.
OVERALL MAINTENANCE :
• Maintenance should always be performed by qualified personnel.
• Always use spare parts provided by Cecotec.
• Any type of reparation must be carried out with the vehicle on the stand and turned off.
• If the scooter is not going to be used for a while, store it indoors in a dry and shady place.
Avoid long-term outdoor storage.
• Sunshine exposure, overheating and overcooling will accelerate the appearance of
damage signs and will reduce the service life of the electric scooter and its battery.
BATTERY MAINTENANCE AND TREATMENT:
• Do not use battery packs of other models or brands, otherwise there may be safety risks.
• It is forbidden to touch the battery contacts and to dismantle or puncture the shell. Avoid
short circuit caused by metal contact with battery contacts.
• Only the original charger can be used for charging, otherwise there is danger of fire.
• After each use, please charge the battery before storing the electric vehicle, which is
conducive to prolonging the battery life.
• Do not place the battery at temperatures above 50 ºC or below -20 ºC.
CHECKS TO BE CARRIED:
• After a fall, check that the throttle push button/trigger operates correctly. To do so, try to
accelerate and decelerate a few times.
• From time to time, check that the brakes operate properly. To do so, move the vehicle
pushing it manually and brake suddenly to ensure they respond.
• Check all the parts of the vehicle are in place and securely assembled.
• Check the wear of the tyres and their pressure.
• Check the wear of the brakes and the throttle cables.
36

7. TROUBLESHOOTING

ERROR CAUSE
The engine does not work. The battery is not connected.
The battery is low.
Electrical problem.
The engine switches off during The break of the circuit is
use. tripped.
After charging, the vehicle turns The battery is not fully
off . charged.
The battery is frozen.
The battery is old or does not
work properly.
The battery does not charge. Low battery.
Broken battery charger.

Other errors:

• E1: Motor error
• E2: Controller signal error
• E3: Throttle error
• E4: Controller MOS error
• E5: Phase current error
• E6: Average current error
• E7: Battery voltage error
• E8: Handle brake error

8. TECHNICAL SPECIFICATIONS

Product and reference:
07033 – Bongo Serie S Infinity
Battery: 36 VDC, 7800 mAh
Maximum power: 750 W
ENGLISH
SOLUTION
Check the connectors.
Recharge the battery.
Check all connectors.
Release the throttle and
wait until it cools down.
Recharge the battery.
Heat the battery.
Replace the battery.
Replace the battery.
Replace the battery charger.
37