Herunterladen Inhalt Inhalt Diese Seite drucken

Supervise Young Children To Make Sure That They Do Not Play; Product Assembly - cecotec bongo S Serie Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 26
ENGLISH
If the user that is going to use the product is not familiar
with riding this type of vehicles, it is recommended that an
adult teaches before first use:
1. Acceleration.
2. Deceleration.
3. Braking.
4. Basic riding principles.
Before each use, check the brakes, the pressure and
condition of the tires and the throttle. If any unusual noise
or fault is detected, do not use the product and contact the
Technical Support Service of Cecotec.
Any alteration of the product is not allowed, as this can
change its performance or damage its structure causing
injuries.
Make sure to turn off the product before parking it.
Do not ride the vehicle under rain, snow or wet conditions.
Avoid the vehicle's electric parts from getting into contact
with water or other liquids. Avoid riding it near rivers or
lakes.

Supervise young children to make sure that they do not play

with the appliance. Close supervision is necessary when
the appliance is being used by or near children.
DRIVING CONDUCT INSTRUCTIONS
Do not use the phone or listen to music while riding the scooter.
Only drive when there is enough light as to do it safely. Do not drive at night.
Drive always holding the handlebar with both hands.
While driving, your feet must always be comfortably and solidly placed on the board.
Do not distract during the ride, always look ahead.
Always ride at a speed as to allow you to stop safely.
Start braking at enough distance from obstacles, curves and from areas where the type
of floor changes. Remember to release the throttle before braking.
Do not race other drivers.
A minimum safety distance of 5 m should be kept from other vehicles.
30
4. PRODUCT ASSEMBLY AND ADJUSTMENT
NOTE: The vehicle is shipped folded.
UNFOLDING THE SCOOTER'S STEM:
1.
Make sure the device is completely turned off.
2.
Pull up the stem up and release the stem from the rear mudguard.
3.
Raise the stem, place the folding tab in a close position and lower the fixing ring to hold
the tab.
FOLDING THE SCOOTER'S STEM:
4.
Slide up the fixing ring.
5.
Open the folding tab.
6.
Lower the folding tab and then the stem.
7.
Align the closing hook with the gap on the rear fender.
ENGLISH
31

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis