Screen Saver Mode; Turning The Power On/Off; Symbols Used In These Operating Instructions; Region Settings - Panasonic KX-TG9120EX Bedienungsanleitung

TG9120_40_50EX(e).book Page 14 Monday, August 7, 2006 3:52 PM
Preparation
Battery strength
Battery icon Battery strength
High
@
Medium
?
Low
/
When flashing: Needs
to be charged.
Panasonic Ni-MH battery performance
(included batteries)
Operation
In continuous use
In continuous
standby mode
Note:
L It is normal for batteries not to reach full
capacity at the initial charge. Maximum
battery performance is reached after a few
complete cycles of charge/discharge
(use).
L Actual battery performance depends on a
combination of how often the handset is in
use and how often it is not in use
(standby).
L Battery operating time may be shortened
over time depending on usage conditions
and ambient temperature.
L Even after the handset is fully charged,
the handset can be left on the base unit
without any ill effect on the batteries.
L The battery strength may not be displayed
correctly after you replace the batteries. In
this case, place the handset on the base
unit and charge for at least 7 hours.

Screen saver mode

The backlight will turn off completely
after 1 minute of inactivity if the handset is
not on the base unit.
14
To use the handset when it is in screen
saver mode, first press {ih} to turn the
display on again.

Turning the power on/off

Power on
Press {ih} until a short beep sounds.
Power off
Operating time
Press {ih} for about 2 seconds.
15 hours max.
240 hours max.
Symbols used in these
operating instructions
Symbol
J
i
L
j
X
I
M
3
m
L
" "

Region settings

You can set the unit to use settings that
match your country (page 35). The display
language and other settings will change
accordingly.
Meaning
Press J (centre of joystick).
Proceed to the next operation.
Press L (centre of joystick).
Select the mentioned handset
menu icon (page 11).
Example: m (handset setup
menu icon)
Select m by pushing the
joystick in any direction.
Select the words in quotations
shown on the display (e.g.,
"Time Settings") by
pushing the joystick up or
down.