Panasonic KX-TG9120EX Bedienungsanleitung Seite 67

TG9120_40_50EX(e).book Page 67 Monday, August 7, 2006 3:52 PM
SMS (Short Message Service)
Problem
I cannot send or receive SMS
messages.
The SMS message centre number
is logged in the caller list but a
message was not received.
"FD" is displayed.
"FE" is displayed.
"E0" is displayed.
"Q" is not displayed after I read a
message.
Cause & solution
L You have not subscribed to the appropriate service.
Consult your service provider/telephone company.
L The SMS message centre number(s) are not stored
or are incorrect. Store the correct numbers (page
41).
L Message transmission was interrupted. Wait until
the message has been sent before using other
telephone functions.
L Your unit is connected to a telephone line with
DSL/ADSL service. We recommend connecting a
filter (contact your DSL/ADSL service provider) to
the telephone line between the base unit and the
telephone line jack.
L Belgium:
To send SMS messages, enter the destination
number followed by the receiver's terminal number
("Writing and sending a new message (to a
phone)", page 41). To receive SMS messages,
store your terminal number after the Message
centre 2 number and tell it to the sender ("Storing
SMS message centre numbers", page 41).
L Someone tried to send you a message while SMS
was turned off.
L The unit could not connect to the SMS message
centre. Confirm that the correct SMS message
centre numbers are stored (page 41). Confirm that
SMS is turned on (page 41).
L An error occurred while sending the message. Try
again.
L Your phone number is permanently withheld or you
have not subscribed to the appropriate service.
Consult your service provider/telephone company.
L When an error code ("FD", "FE", or "E0") is
displayed, "Q" will not be displayed even if you
have read the message.
Useful Information
67