Activation/Deactivation Of Ph Regulation; Manual Injection - ULS PAPI004231-INTER5 Gebrauchsanweisung

OK
OK
(Wait a few seconds)
OK
(Wait a few seconds)
or

7.6.17. Activation/deactivation of pH regulation

Menu

7.6.18. Manual injection

Menu
Priming
peristaltic
and filling of semi-
rigid pipes.
pH
injection.
Means of checking
the
operation of the
peristaltic pump.
Insert the probe into the pH 7 calibration solution, then wait a few minutes.
Do not touch the probe.
a) Rinse the probe under running water, then leave it to drip-dry without wiping it.
b) Insert the probe into the pH 10 solution, then wait for a few minutes.
Do not touch the probe.
a) Rinse the probe under running water, then leave it to drip-dry without wiping it.
b) Install the probe into the probe holder.
Perform the navigation again with the above instructions, several times if necessary.
If calibration still fails, replace the probe then perform another calibration.
Possible settings
ON
OFF
Functions Possible settings
of the
pump
30 seconds to 10
minutes
corrector
second
increments.
correct
Default setting
in 30-
1 min.
Default setting
ON
Instructions
To start injecting:
Confirm the
setting. (The
pump is running, and the
timer countdown
displayed in real time.)
To pause, and to restart the
injection:
Press OK.
To stop injection:
Press .
duration
peristaltic
is
16