CombiSteel Blastchillers Gebrauchsanweisung Seite 7

IMPORTANT WARNIING: "Atc" and "btc" alarms can also occur in where the ambient temperature
is high or too low. Please note that in this case the ventilation of the place must be checked.
The "Atc" and "btc" alarms may lead to compressor failure and won´t covered by guarantee.
Indicates that there is a power failure alarm. Device warns of electricity is
interrupted for a certain time. Note: to return to normal working, pressing any
key then restart the cycle.
Cycle doesn't reach to the set operation point. Check the loading capacity of the
product. For stopping the cycle press and hold chilling/freezing key for 3
seconds. If you want to continue, do not act anything.
External Alarm. Contact authorized service.
External Alarm. Contact authorized service.
Door switch alarm. If the door remains open for more than 1 minute, the alarm
will start. Close the door. If the alarm continues control the door connections or
contact technical service.
Condenser overheated alarm. Condenser reaches to the first critical
temperature. Please plug out the product. Clean the condenser and wait 30
minutes. Then restart the product again. If the alarm continues please contact
technical service.
Condenser low temperature alarm. Control the ambient temperature. Clean the
condenser. Call authorized service.
www.combisteel.com
7