Dixell Blast Chiller/Freezer Manual; Important Matters; Frequently Used Leds/Alarms - CombiSteel Blastchillers Gebrauchsanweisung

DIXELL BLAST CHILLER/FREEZER MANUAL

IMPORTANT MATTERS:

PLUG IN THE PRODUCT. YOU WILL SEE HOLD ALARM ON DISPLAY. (ONLY ON THREE-PHASE 380 V UNITS). YOU
CAN START THE FREEZING/CHILLING OPERATIONS IN 45 MINUTES.
IN ORDER TO OPEN THE PRODUCT PRESS AND HOLD THE
BEFORE FILLING THE FOOD INSIDE THE PRODUCT, APPLY THE CHILLING CYCLE. (AFTER FINISHING THE CHILLING
CYCLE (90 MINUTES) YOU CAN FILL THE PRODUCT AND START YOUR DESIRED ROGRAM. IN ORDER TO START THE
CHILLING CYCLE PRESS
THE PRODUCT STARTS THE TEMPERATURE-CONTROLLED CYCLE AUTOMATICALLY.
IN ORDER TO START THE TIME-CONTROLLED CYCLE, KEEP THE NEEDLE PROBE OUTSIDE THE PRODUCT OR
OPERATE AS FOLLOW: PRESS AND HOLD THE FREEZING/CHILIING KEY FOR 10 SECONDS. YOU WILL SEE cYS
PARAMETER ON SCREEN. THEN CHANGE THE cYS PARAMETER FROM tEP TO tiM BY
SET AND WAIT FOR 30 SECONDS.
PLEASE PLUG-OUT THE UNIT IF IT IS NOT USED FREQUENTLY.

FREQUENTLY USED LEDS/ALARMS:

COMPRESSOR ENABLED
1, 2, 3, 4 OR HOLD MODE ACTIVE. (1 IS SOFT CHILLING, 3 IS HARD CHILLING, 2 IS SOFT FREEZING AND
4 IS HARD FREEZING CYCLE). IF IT IS FLASHING: CYCLE NOT YET SELECTED OR CYCLE TEMPORARILY
SUSPENDED.
IP3
DISPLAY NEEDLE PROBE. (IF THE SCREEN SHOWS IP3 / END, IT MEANS THAT THE TEMPERATURE-
CONTROLLED CYCLE IS FINISHED SUCCESSFULLY). IN TIME CONTROLLED CYCLE NORMALLY YOU WILL
SEE THIS ALARM.
INDICATES THAT THERE IS A POWER FAILURE ALARM. DEVICE WARNS OF ELECTRICITY IS
INTERRUPTED FOR A CERTAIN TIME.
NOTE: TO RETURN TO NORMAL WORKING, PRESSING ANY KEY THEN RESTART THE CYCLE.
CYCLE DOESN'T REACH TO THE SET OPERATION POINT. CHECK THE LOADING CAPACITY OF THE
PRODUCT. FOR STOPPING THE CYCLE PRESS AND HOLD CHILLING/FREEZING KEY FOR 3 SECONDS. IF
YOU WANT TO CONTINUE, DO NOT ACT ANYTHING.
KEY TWICE & FOR FREEZING OPERATION PRESS
FAN ENABLED
www.combisteel.com
KEY FOR 2 SECONDS.
KEY TWICE)
DEFROST ACTIVE
KEYS THEN PRESS
3