STARTING THE PROGRAM:
Make sure no procedure is in progress. Select SOFT/HARD option by
indicates the SOFT cycle and
In order to select the temperature-controlled Blast Chilling, press
In order to select the temperature-controlled Blast Freezing, press
SET point for Blast Chilling is -3〬C and SET point for Blast Freezing is -30〬C. Needle probe SET point for Blast
Chilling is 0〬C and needle probe SET point for Blast Freezing is -18〬C.
The product starts the Holding phase automatically after each operation.
Holding SET point after Blast Chilling is 0〬C and after freezing is -18〬C.
MANUAL INTERRUPTION:
Press and release
by pressing the
FINAL STOP:
Press and release the
in the display indicates the HARD cycle.
the key .The icon for the current cycle starts to flash. The cycle is restarted
key again.
key for 2 seconds.
www.combisteel.com
key. The icons
twice.
twice.
in the display
4