Chapter 2: Single-Unit Chargers; Charging A Stand-Alone Battery - Motorola DLR-Serie Handbuch

MN007800A01-AA

Chapter 2: Single-Unit Chargers

1
2
2.2

Charging a Stand-Alone Battery

When and where to use:To charge a battery, the followings are steps to insert the battery into the
charger pocket.
Procedure:
1 Align the raised tab on each side of the battery with the corresponding groove on each side of
the charger pocket.
2 Press the battery toward the rear of the pocket.
3 Slide the battery into the charger pocket, ensuring complete contact between the charger and
battery contacts.
When the battery is properly seated in the pocket, the charger indicates the battery level status
as shown in Table 6: Charger LED Indicator on page
that the battery is charging rapidly.
The LED changes to a steady green light to indicate that the battery is nearly or fully charged.
10
1
SUC Tray
Power Supply
15. The red LED illuminates to indicate
2
1
2