How To Scan; Step 1 - Powering On The Scanner; Step 2 - Select Film Type - Braun CyberView X5 Handbuch

HOW TO SCAN

Scanning process step-by-step:
Powering on the scanner > Select fi lm type > Optional Prescan >
> Set scan settings > Scan
STEP 1 – Powering on the scanner
Status LED
Power on Cycle
LED Status
Flashes several times,
then a pause,
then fl ashes again
STEP 2 – Select fi lm type
a. Open the CyberView scanning interface.
b. Select the fi lm type to be scanned - Positive, Negative or B&W (Black and
White).
c. Once you have selected a fi lm type you will have the option to select
the frame sizes for the various 120 format fi lms, after you have inserted
the fi lm holder into the unit.
NOTE: The 135 fi lm will be auto-detected, a frame selection is not necessary.
Scanner Status
Unit will take approx. 40-50 sec. to callibrate. The power
LED will be solid blue (not blinking) to indicate that
the scanner is ready to use.
Flashing indicates the scanner is busy, do not insert/re-
move fi lm holders
Scanner is malfunctioning. Turn the unit off , close the
software, power on the scanner, wait for calibration, then
re-open CyberView.
19
17