Canon PIXMA MP600R Installationsanleitung Seite 55

Setting up for use over wired LAN
This section describes how to set up the machine to be used over wired LAN.
Important
Follow this procedure only when the machine has not yet been set up to be connected to a wired
LAN. If the machine has already been connected to a wired LAN, see "Setting up an additional
LAN-connected computer" on page 58.
1
Confirm that the screen shown on the right
appears.
Important
This step should follow from step 9 in "Installing the
Software" on page 42. If the Setup Preparations
screen has not displayed yet, go back to the procedure
in "Installing the Software" on page 42 to complete the
installation of the software.
2
Connect the machine with a USB cable.
Note
To set up the machine that is not yet connected to a
LAN, connect to it with a USB cable.
3
Turn on the machine.
4
Click OK on the Setup Preparations screen.
52 Setting Up the Machine and the Computer (Macintosh)