Canon PIXMA MP600R Installationsanleitung Seite 33

7
Confirm that the setup program detects the machine automatically.
MP600R connected with the USB cable is detected automatically via the access point.
When the machine is detected automatically
The machine is detected automatically if no operation is required for connecting to the
machine. Go to step 8 to proceed with the setup.
If the Set Printer IP Address dialog box is
displayed
If the machine is not detected automatically, the
Set Printer IP Address dialog box is displayed.
Click Connect to connect to the machine. If the
machine is still not detected, see "The Set Printer
IP Address dialog box is displayed during setup" on
page 69.
8
When the Network Setup of the Card Slot
dialog box is displayed, specify the drive
letter, then click Next.
If "Communication with the Card Slot failed." is
displayed
Click Retry. If it still fails, see ""Communication with
the Card Slot failed" is displayed during setup" on
page 72.
Note
If "Cannot map any more drives, because all the
drive letters are assigned" is displayed, make an
available drive letter manually, and try the network
setup of the Card Slot again.
If "The Card Slot is already mapped as Network
Drive to this computer" is displayed, the Card Slot is
already set up. Click OK, then click Next.
30 Setting Up the Machine and the Computer (Windows)