Re-Setting The Machine; The Admin Password Set To The Machine Was Forgotten; The Card Slot Is Already Mapped As Network Drive To This Computer" Is Displayed During Setup; The Admin Password Was Forgotten - Canon PIXMA MP600R Installationsanleitung

Problem
"Communication with the Card Slot
failed" is displayed during setup
(Continued)
"The Card Slot is already mapped as
Network Drive to this computer" is
displayed during setup
"Cannot map any more drives, because
all the drive letters are assigned" is
displayed during setup

Re-setting the machine

Problem

Re-setting the machine

The admin password set to the machine was forgotten

Problem

The admin password was forgotten

72 Troubleshooting
Possible Cause and Measures
Change the workgroup name to "WORKGROUP" following the procedure
below.
(1) Right-click My Computer, then select Properties.
(2) Select the Computer Name tab, then click Change.
(3) Change the workgroup name to "WORKGROUP", then click OK.
If these do not resolve the problem, click Skip to complete the setup without the
network setup of the Card Slot. To mount the Card Slot as the network drive
after setup, refer to the Network Guide on-screen manual.
The Card Slot is already available. Click OK to close the dialog, then click Next
on the Network Setup of the Card Slot dialog box.
Make a drive letter manually, and try the network setup of the Card Slot again.
Possible Cause and Measures
Set the machine setting to the default and set up the machine again. For details,
see "Printing and Initializing Network Settings" on page 75. For setup
procedures, see "Confirming the Setup Environment" on page 20.
Possible Cause and Measures
Set the machine setting to the default. All settings previously set will be lost after
initialization. Set up the machine again to use it. For details, see "Initializing
using the Operation Panel" in "Printing and Initializing Network Settings" on
page 75.