Preparing The Machine; Turning On The Machine - Canon PIXMA MP600R Installationsanleitung

Preparing the Machine

Note
Please confirm the included items against the illustration printed on the lid of the packing box.
Even though the machine is intended to be used on a wireless or wired LAN, it must be placed
temporarily near the computer to do the setup via a USB cable. Place the machine in the location where
you will use it over a wireless or wired LAN as instructed during setup.
Although wireless communication between rooms or floors is possible, the wireless communication
quality may become poor. The wall must be made of a material that allows radio waves to pass through.
If the wall material prevents communication, set the machine in the same room as the access point.

Turning on the Machine

Warning
Never attempt to plug the power cord into the wall outlet or unplug the power cord when your hands are
wet.
Never damage, modify, stretch, or excessively bend or twist the power cord. Do not place heavy objects
on the power cord.
Never use any power supply other than the standard power supply available in the country of purchase.
Using the incorrect voltage and frequency could cause a fire or electric shock.
Always insert the plug all the way into the wall outlet.
Caution
Make sure to hold the base of the machine when lifting it out of the packing box or moving it.
Note
If you do not intend to use the machine for a long period of time, unplug the power cord from the wall outlet
after turning off the machine.
1
Place the machine to set up.
Place the machine on a flat and horizontal surface, and do not place any objects in front of the
machine.
Caution
Before turning on the machine, remove all of the shipping tapes.
2
Open the Sheet Feeder Cover (A) and pull
the Paper Support (B), then the Paper Output
Tray (C) and open the Output Tray Extension
(D).
Note
To open the Paper Output Tray, put your finger in the
rounded indent of the tray and open it gently.
10 Preparing the Machine
(B) (B)
(A)
(C)
(D)