Registering The Handset - Siemens GIGASET 4000i COMFORT Bedienungsanleitung

Registering the handset

To make calls with your handset, you must "intro-
duce" it to its base station (registering)
G if your handset has already been registered at a dif-
ferent base station (steps 1, 2 and 3) or
G if you want to register the handset as a new hand-
set at a Gigaset base station of an older Gigaset
range (steps 1, 2 and 3).
Step 1: On the base station or on the base station
telephone:
Gigaset
4010/4015
3010/3015
3020/25
3030/35
4030/35
3070/75
4070/75
Non-Sie-
mens base
stations
Step 2: On the handset:
©
D
H/Set Settings
D
Register H/Set
D [
Step 3: On the handset:
o
[
Your handset is now ready for operation!
Your handset can be registered at up to four base sta-
tions.
Up to three handsets can be registered with the Gi-
gaset 4010i base station.
10
On the base station or base telephone
Hold down the key on the underside of
the base station.
Hold down the paging-key
station until you hear signal tones.
settings
Select
handset
in the menu at the base station
telephone and confirm with
Press the LED – it will flash during regis-
tration.
To register at "GAP base stations" , follow
the relevant operating instructions
(steps 2 and 3).
Press the display key.
[
Select and confirm.
[
Select and confirm.
Select the base station.
Enter the system PIN and con-
firm (factory setting 0000) – e.g.
Regstr.Procedure Base 1
system settings
,
y
on the base
register
and
OK
.
is displayed.