Registering The Handset - Siemens Gigaset 4000 Classic Bedienungsanleitung Und Sicherheitshinweise

Gigaset 4000 Classic, IM1 eng, A31008-G4000-B001-2-6Z19

Registering the handset

To make calls with your handset, you must "intro-
duce" it to its base station (registering)
G if your handset has already been registered at a dif-
ferent base station (steps 1, 2 and 3),
G if you want to register the handset as a new hand-
set at a Gigaset base station of an older Gigaset
range (steps 1 and 3).
Step 1: On the base station or base telephone
Gigaset On the base station/base telephone
4010/4015 Hold down the key on the underside
of the base station.
3010/3015 Hold down the paging-key
base station (for about 10 seconds) un-
til you hear signal tones.
3020/25 Select
3030/35 and
4030/35 the base station telephone and con-
firm with
3070/75 Press the LED – it will flash during
4070/75 registration.
Non-Sie- To register at "GAP base stations" , fol-
low the relevant operating instructions
mens base
stations (step 2 and 3).
Step 2: On the handset:
MENU

REGISTER HS
Step 3: On the handset:

OK
Once you have entered the system PIN the handset
will search for a base station with this PIN. During the
search,
REGISTER HS
it has been registered successfully, the handset will
revert to its idle status. Your handset is now ready
for operation.
VHWWLQJV
UHJLVWHUKDQGVHW
2.
.
Open the menu.
Select the menu item and con-
OK
firm.
The PIN is displayed.
Enter the 4-digit system PIN and
confirm.
will flashes on the display. When
4000Cla.fm
#
of the
V\VWHPVHWWLQJV
,
in the menu at
17 .11.00
9