Cleaning The Machine - Stiga CR 430 Serie Gebrauchsanweisung

interchangeable and operating safety features.

4.2 Cleaning the machine

Do not spray water onto the motor and electrical compo-
nents and prevent them from getting wet.
Do not use aggressive liquids to clean the chassis.
4.3 Drive adjustment
On power-driven models, the drive belt tension is obtained
by adjusting the nut (1) until the indicated measurement (6
mm) is obtained.
5. ATTACHMENTS
WARNING! For your safety, it is strictly prohibit-
ed to fit any other attachment other than those included
in the following list, as they have been exclusively de-
signed for the model and type of machine you are using.
5.1 Mulching Kit
(if not included with the equipment)
It chops the grass cuttings finely and leaves them on the
lawn, instead of collecting them in the grass catcher (only
on some models).
6. DIAGNOSTICS
What to do if ....
Problem description
1. The electric lawnmower doesn't work
The machine has no power
supply
2. The electric lawnmower trips the power supply.
The mains socket
amperage is insufficient
Other electrical appliances
are being used
3. The cut grass is not collected in the grass catcher
The cutting means has
received a knock
The inside of the chassis
is dirty
4. Mowing is difficult
The cutting means is not in
good condition
5. The machine starts to vibrate abnormally
Corrective Action
Check the electrical
connection
Connect the machine
to a mains socket with
sufficient amperage
Do not connect other
appliances to the same
mains socket at the same
time
Have the cutting means
sharpened or replace it
Check the fins that direct
the grass towards the
grass catcher
Clean the inside of the
chassis to ease the grass
discharge towards the
grass catcher
Have the cutting means
sharpened or replace it
Damaged or loose parts
6. The motor shuts down whilst working
The thermal protection has
tripped due to overheating
of the motor.
For any doubts or problems, please do not hesitate to con-
tact your nearest Customer Service Centre or Your Dealer.
EN - 6
Stop the machine and
disconnect the plug from
the socket.
Inspect for damage
Check for and tighten any
loose parts
Have all checks, repair
work and replacements
carried out by a specialized
Centre only
Stop the machine and
disconnect the plug from
the socket. Always make
sure the air intakes are free
of debris.