Residual Risk - BATTIPAV PRIME 500 Bedienungsanleitung

Battipav srl
Model PRIME 500S - 650S - 700S
18
1) With a 5 mm Allen wrench, loosen the cut start carriage stopper.
1819
2) Put the carriage stopper in the new position B indicated on the label and lock it again
21
3) Fold up the additional splash guard.
Model PRIME 500 - 650 - 700
4) Repeat the procedure on the end cut carriage stopper.
31
5) Place the working table back in position, observing the distance from the leg support.
CUTTING A SURFACE AT 45°
Before positioning the motor head, make sure that:
• the machine is off;
45° CUT
20
Referring to the graded scale located on the machine upright, move the motor head to the jolly position and tighten the knobs.
21
• Position the piece to be cut on the working table and perform the cutting operation.
LASER MARKER
CLASS IIIA LASER INSTRUMENT
By means of the laser marker accessory, the cutting operations can be accelerated.
As a matter of fact, the special laser system is able to indicate the tool cutting line on the working table.
THE LASER MARKER STARTS WORKING ONCE THE MACHINE IS CONNECTED TO THE POWER SUPPLY.
DIRECT EXPOSURE TO SUNLIGHT MAY REDUCE THE LASER MARKER EFFECTIVENESS.
IT IS THEREFORE ADVISABLE TO USE THE MACHINE INDOORS.
22
CUTTING WITH LASER MARKER
• connect the machine to the power supply;
• position the piece to be cut making sure that the line indicated by the laser marker matches the reference on the material to be cut;
• perform the cutting operation as indicated in the paragraph: "CUTTING ON THE TABLE".
DO NOT MODIFY THE MARKER POSITION BY TURNING THE BEAM TOWARDS THE OPERATOR'S EYES. DO NOT
GAZE AT THE BEAM WITH THE NAKED EYE OR LOOK DIRECTLY WITH OPTICAL INSTRUMENTS.
MARKER ADJUSTMENT
In case the marker is not aligned with the cutting line, its correct alignment can be adjusted.
In order to correctly position the marker, proceed as follows:
23
• loosen the three bulb locking screws so that it can be moved;
22
• position a reference properly on the tool cutting line;
23
• insert the 5 mm Allen wrench provided in the hexagonal slot located on the bulb;
23
• using the Allen wrench, turn the bulb until aligning the mark with the tool cutting line
DURING THE ADJUSTMENT OPERATIONS, MAKE SURE THAT THE LINE PRODUCED BY THE MARKER DOES NOT
REACH THE OPERATOR'S EYES.
ALWAYS KEEP A SAFETY DISTANCE BETWEEN THE OPERATOR'S EYES AND THE END OF THE LINE. THE MANUFACTURER
DECLINES ANY LIABILITY FOR THE USE OF THE LASER MARKER IN APPLICATIONS OTHER THAN THE INDICATED APPLICATION.

RESIDUAL RISK

During the design phase, BATTIPAV SRL paid particular attention to the aspects that may generate risks for the safety and health
of operators. In spite of this, there are still some potential risks, which are described below:
Danger of presence of electric current:
The machine has an internal electric system. CONNECT THE MACHINE TO A SYSTEM WITH DIFFERENTIAL
PROTECTION AND EFFECTIVE EARTH WIRE.
Danger of prolonged exposure to noise:
The continuative use of the machine causes an exposure to noise levels above 85 dB (A).
OPERATORS MUST USE PROPER EAR DEFENDERS.
• the cutting tool is not moving;
GB
31