Signal Restoration - Kicker KEYLOC Benutzerhandbuch

Signal Restoration

Correcting Signal: This 12-step process uses the
KEYLOC's internal DSP to correct factory equalization,
time delay, or phase processing. It takes between
5–10 minutes in most applications to complete. This
process requires you to be able to see the Status
LEDs clearly, as well as access to the INPUT and
OUTPUT gain adjustments, HI/LO switch, and KEY
button on the KEYLOC
IMPORTANT: To perform this step, if you have
not already downloaded them you will need
three tracks from www.kicker.com/test-tones:
GainMatch NoiseFloor FullTest
This is the order in which you will use these files, so
this is the order you should use when saving them to
a USB stick or burning them to an Audio CD.
NOTE: There are both MP3 and WAV files available.
NOTE: If you press the KEY button at the wrong time
during this process, you will get an error code - all
blue LEDs blinking. If this happens, press and release
the KEY button to exit the process, and then start
over from the beginning.
English 16