Before You Start - NORAUTO NO3023 Bedienungsanleitung

7. Use only the provided hardware and wire harness.
8. You cannot view video while the vehicle is moving. Find a safe place to park and
engage the parking brake.
9. If you experience problems during installation, consult your nearest Norauto shop.
10. To clean the monitor, wipe only with a dry silicone cloth or soft cloth. Do not use a
stiff cloth, or volatile solvents such as paint thinner and alcohol. They can scratch
the surface of the panel and/or remove the printing.
11. When the temperature of the unit falls (as in winter), the liquid crystal inside the
screen will become darker than usual. Normal brightness will return after using
the monitor for a while.
12. When extending the ignition, battery or ground cables, make sure to use
automotive-grade cables or other cables with an area of 0.75mm (AWG 18) or
more to prevent voltage drops.
13. Do not touch the liquid crystal fluid if the LCD is damaged or broken. The liquid
crystal fluid may be hazardous to your health or fatal. If the liquid crystal fluid
from the LCD contacts your body or clothing, wash it off with soap immediately.
PREPARATION

BEFORE YOU START

• Disconnect negative battery terminal. Consult a qualified technician for instructions.
• Avoid installing the unit where it would be subject to high temperatures, such as from
direct sunlight, or where it would be subject to dust, dirt or excessive vibration.
INSTALLATION GUIDE
Mounting SCREWS
MOUNT I NG S CR E WS
M2.6 × 6.0 mm M5.0 × 6.0 mm
M2.6 x 6.0mm M5.0 x 6.0mm
TRIM RING
T R I M R I NG
MOUNTING BRACKET
MOUNT I NG B R ACK E T
M5.0 × 5.0 mm M5.0 x 5.0mm
EN
VERTICAL (0°)
83