Drinking Water Withdrawal; Filter Change - Vision Aqua Verdanium Home Gebrauchsanleitung

Drinking water withdrawal

Please open the withdrawal tap.
If the Verdanium Home is in standby mode for more than 15 minutes, it will produce drinking water only
after approx. 15 - 30 seconds. During this time, the filter is rinsed and prepares itself for ultra-pure water
production (Permeatproduktion).
The following messages appear on its display:
PERMEATPRODUKTION
Automatic
Membran spülen
ESC ← 080%
After rinsing, the Verdanium Home automatically changes to ulta-pure water production. The following
messages appear on its display:
PERMEATPRODUKTION
Gerät in
Betrieb
ESC ←
To stop ultra-pure water production, close the withdrawal tap.
After the water production finishes, the system prepares for standby mode (Nachspülen). The following
messages ap-pear on the display:
PERMEATPRODUKTION
Automatic
Nachspülen
ESC ← 050%
The Verdanium Home is now in standby mode.
54 Instruction Manual – Verdanium Home – Ver. 2.2.1 – 04.2021
PERMEATPRODUKTION
Permeat spülen
ESC ← 030%
PERMEATPRODUKTION
Gerät bereit
ESC ←
As soon as the message "Attention! Maintenance required! Please replace all filter units!" (Achtung War-
tung! Bitte alle Filtereinheiten austauschen!) appears on the display, the pre- and post-filters need to be
changed.
The message „Attention maintenance required! Please replace all filter units!" (Achtung
Wartung! Bitte alle Filtereinheiten austauschen!) is only displayed during the annual filter
change.
The semi-annual pre-filter change must be scheduled and performed by the user.
PERMEATPRODUKTION
Gerät in
Stop the permeate production mode (Permeatproduktion)
with the
Betrieb
→ OK
Vorbereitung
Select in the menu the operating maintenance preparation
Wartung
mode (Vorbereitung Wartung). Confirm with the
Follow the instructions on the display.
ESC ← → OK
- Eckventil schließen
Disconnect the water supply to your device and open the with-
drawal tap. Confirm with the
- Entnahmehahn öffnen
After you open the withdrawal tap, the pressure in the supply
tube will be reduced. Please wait until the next instruction is
→ OK
shown on the display.
- Schlauch vom
Eckventil trennen
Now disconnect the inlet tube from the angle valve and press
the OK-Button
→ OK
Reset nach Filter-
wechsel:
To reset the filter change interval (Reset nach Filterwechsel),
Tasten
you must select in the operating mode menu the buttons (B)
and (–) and hold them for at least 5 seconds.
"B" und "–" 5s
Halten: 00005s
Instruction Manual – Verdanium Home – Ver. 2.2.1 – 04.2021

Filter change

ESC-Key.
OK-Button.
OK-Button.
to confirm.
55