Folgen für die menschliche Gesundheit und die natürliche Umwelt bei, die aus der Anwesenheit von Schadstoffen sowie einer falschen Lagerung und Weiterverarbeitung solcher Materialien folgen. WEEE Reg. Nr.: DE 20879980 Gebrauchsanleitung – Verdanium Home – Ver. 2.1.1 – 12.2020 Gebrauchsanleitung – Verdanium Home – Ver. 2.1.1 – 12.2020...
Die Verdanium Home nur dann bedienen, wenn Sie den Inhalt dieser Betriebsanleitung zur Kenntnis genommen haben. Bedienung Die Reinigung und Wartung der Verdanium Home darf von Kindern nicht erfolgen, es sei denn, dass sie das • 8. Lebensjahr vollendet haben und von einer zuständigen Person beaufsichtigt wurden.
Wechseln Sie die AA LR 6 Batterie nach jedem Filterwechsel oder einmal im Jahr. Sowohl der Anschluss am Eckventil als auch an der Verdanium Home wird unter vollem Lei- Um einen einwandfreien Betrieb der Verdanium Home zu gewährleisten, muss die tungsdruck stehen und sollte besonders sorgfältig hergestellt werden.
Art.-Nr.: PE-08-BI-0500F-N Sowohl der Anschluss am Entnahmehahn als auch an der Verdanium Home werden unter Sowohl der Anschluss am Eckventil als auch an der Verdanium Home wird unter vollem Lei- vollem Leitungsdruck stehen und sollen besonders sorgfältig hergestellt werden. Prüfen Sie tungsdruck stehen und sollte besonders sorgfältig hergestellt werden.
Abfluss Anschluss Vorratsbehälter für Wasch-/Spülmaschine (Optional) Der Abfluss der Verdanium Home lässt sich problemlos an alle 40 mm starken Kunststoffrohre anbringen. Für den Anschluss einer Wasch-/ bzw. Spülmaschine an das Reinstwasser wird ein separat erhältlicher Bevor Sie mit der Installation beginnen, bestimmen Sie die Montagestelle der Abflussschelle.
Lösen der Verbindung Überprüfen Sie, ob das System drucklos ist. Anschließend kann das Rohr durch Zurückdrücken des Halte- elementes gelöst bzw. entfernt werden. Gebrauchsanleitung – Verdanium Home – Ver. 2.1.1 – 12.2020 Gebrauchsanleitung – Verdanium Home – Ver. 2.1.1 – 12.2020...
Kaltwasseranschluss • Verbinden Sie die Verdanium Home mit dem mitgelieferten Kaltgerätekabel und anschließend mit der Elektroinstallation. • Wird der Netzschalter eingeschaltet ( I ), wird die Verdanium Home aktiviert und wartet auf die erste Inbetriebnahme. Hydro-Stopper am Eckventil montiert 1/4“-Schlauch Abwasser 3/8“-Schlauch...
Sollte sich die Verdanium Home länger als 15 Minuten im Standby-Modus befinden, bekommen Sie das Navigieren Sie mit der ( + )- oder ( – )-Taste, um die Betriebsart zu aktivieren, Trinkwasser erst nach ca. 15 - 30 Sekunden. In dieser Zeit bereitet sich die Verdanium Home auf die Wasser- drücken Sie die OK-Taste.
Werkzeug durchführen. Nehmen Sie die erste PP Filtereinheit nach vorne aus dem Eckventil trennen Trennen Sie jetzt den Zulaufschlauch vom Eckventil und drü- Verdanium Home hinaus und drehen Sie Filterkartuschen gegen den Uhrzeigersinn um 90 ° aus den Filter- cken anschließend die OK-Taste zur Bestätigung.
Verbinden Sie die Verdanium Home wieder mit den Entnahmestellen, der Wasserzufuhr und dem Abfluss. Stellen Sie die Stromversorgung wieder her und schalten Sie die Verdanium Home ein. Positionieren Sie die Verdanium Home wieder an ihren ursprünglichen Platz. Beachten Sie bitte den Ab- Filter spülen Membran spülen...
Bevor Sie weitere Schritte einleiten, kontaktieren Sie Ihren Fachhändler und lassen Sie sich beraten. Garantie Wenn es sich herausstellen sollte, dass Teile der Verdanium Home fehler- bzw. mangelhaft sind (ausge- nommen die austauschbaren Filtereinheiten), dann benachrichtigen Sie bitte Ihren Fachhändler. Das beschä- Abflusschelle 1/4“...
Gives instructions to avoid danger Information Highlights important information concerning the handling of the water fil- ter or the relevant part of the instructions. Gebrauchsanleitung – Verdanium Home – Ver. 2.1.1 – 12.2020 Instruction Manual – Verdanium Home – Ver. 2.1.1 – 12.2020...
Seite 17
Contents Basic information Basic information Dear Customer, Starting today, making your own ultra-pure water is easier than ever. The Verdanium Home made by VISION Device usage AQUA Technology is very easy to use and simple to maintain. Manufacturers declaration Safety instructions...
Before transportation, you must first drain the Verdanium Home. Use the drain program. Before dismantling you must disconnect the Verdanium Home from the electrical grid. Label The label with the basic information about the Verdanium Home is located at the upper rear part of the housing. Operation Children below the age of eight must not clean or maintain the Verdanium Home unless supervised by a Standardinstallation unter der Küchenspüle...
Change the AA LR 6 battery after each filter change or at least yearly. Both the connection to the angle valve and the Verdanium Home is under full water pressure Both the connection to the angle valve and the Verdanium Home is under full water pressure and should be installed with particular care.
Drainage Before installing the withdrawal tap, determine its installation point. You can easily connect the drain tube of the Verdanium Home to all 40 mm thick plastic drainage pipes. Be- • fore you start with the installation, determine the positioning of the drain clamp.
AD to 1/4“ connector - to 1/4“ tube AD Stem Tee Art.-Nr.: CI220808W Art.-Nr.: CI530808W Drain clamp Storage tank Withdrawal tap Instruction Manual – Verdanium Home – Ver. 2.1.1 – 12.2020 Instruction Manual – Verdanium Home – Ver. 2.1.1 – 12.2020...
Connect the Verdanium Home with the supplied power cable to the electrical grid. • When the power switch ( I ) is turned on, the Verdanium Home starts and waits for the initial commissioning to begin. Checking of a connection by pulling Check if the tubes are securely inserted by attempting to pull the tubes out of the connector.
1/4“ tube wastewater Storage tank connection kit Verdanium Home 3/8“ tube Storage tank for water supply Verdanium Home Instruction Manual – Verdanium Home – Ver. 2.1.1 – 12.2020 Instruction Manual – Verdanium Home – Ver. 2.1.1 – 12.2020...
While rinsing the membranes, the disinfectant is removed from the membrane and drains into the waste- water tube connection. During the last phase of commissioning, the Verdanium Home rinses the ultra-pure water side of the mem- branes and the post-filters.
If the Verdanium Home is in standby mode for more than 15 minutes, it will produce drinking water only after approx. 15 - 30 seconds. During this time, the filter is rinsed and prepares itself for ultra-pure water production.
You will need a T 20 Torx screwdriver. Press the new filter cartridges into the filter heads of the Verdanium Home and turn them 90 ° clockwise. Unscrew the 5 housing screws – please do not use excessive force when loosening the screws.
Contact your authorised service When the IB program is completed, and the extraction tap is open, the Verdanium Home changes automati- water. provider. cally to permeate production. The Verdanium Home is now ready for use.
Warranty Packaging Content In the unlikely event that parts of the purchased Verdanium Home are faulty or defective (except the chan- 1 x Verdanium Home (without accessories) geable filter cartridges) please contact your authorised service provider. The defective part or unit will be 2 x VA-Standard PP –...
Maintenance record Notes Date Type of maintenance Stamp Next date Instruction Manual – Verdanium Home – Ver. 2.1.1 – 12.2020 Instruction Manual – Verdanium Home – Ver. 2.1.1 – 12.2020...
Seite 31
® VISION AQUA VISION AQUA Technology GmbH Dorfstr. 20 85298 Scheyern/Vieth – Germany www.vision-aqua.ch mail-info@vision-aqua.ch 4 260645 520059...