Withdrawal Tap - Vision Aqua Verdanium Home Gebrauchsanleitung

Withdrawal tap

Before installing the withdrawal tap, determine its installation point.
•
The withdrawal tap should be in an easy-to-use place. Please pay attention to the rotation
of the existing faucet.
•
Measure the thickness of the tabletop (40 mm max.).
•
Consider the installation and connection options under the sink.
For the bore required in the countertop or the sink, please use drill sizes 3 mm, 7 mm and 12 mm. Start with
the smallest diameter and low drill RPM and increase the speed slowly.
Use a round file to clean the bore and remove any burr residues. For installation of the withdrawal tap into
stone tabletops or sinks, (granite, marble etc.), please follow the drilling regulations of the manufacturer.
Please use the illustration below as a reference for the installation of the withdrawal tap and proceed as
follows:
•
Insert the supplied parts in the correct order on the threaded tube.
•
Correctly align the withdrawal tap.
•
Install the withdrawal tap by tightening the wing nut.
Both connections to the angle valve and the Verdanium Home are under full water pressure
and should be installed with particular care. Check that both connections, with the angle
valve opened, are leak-proof.
44 Instruction Manual – Verdanium Home – Ver. 2.2.1 – 04.2021
To
Verdanium
Home
Instruction Manual – Verdanium Home – Ver. 2.2.1 – 04.2021
Withdrawal tap
Waterspout
Thread
Tap base
Tabletop
Large plastic ring washer
Wing nut
Connection adapter 1/4"
Plastic tube 1/4"
Art.-Nr.: PE-08-BI-0500F-N
45