Hama 00040074 Bedienungsanleitung Seite 7

5.1 Direct code entry
A code list is included in the universal remote control's extent of delivery. The
code list contains four-digit codes for setting the remote control to work with
most AV equipment manufacturers.
For easy orientation, the codes are sorted rst by type of device (TV, DVD, etc.)
and within the type of device alphabetically by brand name.
5.1.1 Switch the device you wish to operate on.
5.1.2 Press the "SETUP" button until the LED lights up continuously.
5.1.3 Use the device button to select the device to be operated (e.g. TV).
If the selection is successful, the LED flashes once and then lights up
permanently.
5.1.4 Search the code list for the brand and type of the device to be operated.
5.1.5 Enter the corresponding four-digit code using the number buttons 0-9.
The LED confirms the entry of each digit with a short flash and goes out
after the fourth digit.
5.1.6 Then test the remote control and check whether the desired functions can
be controlled. It is possible that the first code is not the most suitable,
and possibly not all functions are available. In this case, try the next code
mentioned for the selected device type/brand from the list.
Note
• A valid code is automatically saved.
• If an invalid code is entered, the status LED ashes 3 times and then lights
up permanently. A new code can then be entered.
• If no device selection is made, the last device selection made is
automatically used.
5.2 Manual code search
The universal remote control has an internal memory that already contains up to
350 codes per device type for the most common AV devices. You can go through
these codes until the device to be operated shows a response. For example, the
device to be operated switches off ("POWER" button) or changes channel ("CH+/
CH-" buttons).
5.2.1 Switch the device you wish to operate on.
5.2.2 Press the SETUP button until the LED lights up permanently.
5.2.3 Use the device button to select the device to be operated (e.g. TV).
If the selection is successful, the LED flashes once and then lights up
permanently.
5.2.4 Press the "POWER" or "CH+/CH-" button to scroll through the preset codes
until the device to be operated shows a response.
5.2.5 Press "SETUP" to save the code and exit the code search. The LED goes
out.
5.2.6 Then test the remote control and check whether the desired functions
can be controlled. It is possible that the first code found is not the most
suitable, and possibly not all functions are available. In this case, repeat
steps 5.2.1. – 5.2.5. The code search starts with the next code following
the last one saved.
5