Learning Function - Hama 00040074 Bedienungsanleitung

6.3.2 To deactivate the Macro Power function:
• Press and hold the [MUTE] and [Vol+] buttons simultaneously for approx. 3
sec. until the status LED lights up continuously.
• Use the device button to select the device to be operated (e.g. [TV]). A
successful selection is indicated by the status LED ashing once and then
lighting up continuously.
• Enter the code [9] [5] [0], the status LED ashes 2 times and then lights up
permanently.
• Use the device button to select the second device (e.g. [STB]) that was
previously switched on. A successful selection is indicated by the status LED
ashing once and then lighting up continuously.
• Press the [EXIT] button. The setting has been deactivated when the status LED
ashes 3 times and then goes out.
Note
• If an invalid code is entered, the status LED ashes 3 times and then lights
up permanently. A new code can then be entered.
• Setup mode is automatically terminated after approx. 30 seconds if no
button is pressed. The status LED ashes 3 times and then goes out.

7. Learning function

This remote control is equipped with a learning function. This allows you to
transfer functions from your original remote control to this universal remote
control.
7.1 Before you start the learning function
• Make sure that all batteries used in both remote controls are in perfect
condition. Change them if necessary.
• Place your original remote control and the universal remote control next to
each other so that the infrared diodes of the remote controls are directly
opposite each other.
• If necessary, correct the height of both remote controls to achieve optimal
alignment.
• The distance between the two remote controls should be approx. 3 cm.
Note
• Do not move the remote controls during the learning process.
• Make sure that the room lighting is not uorescent tubes or energy-saving
lamps, as these could cause interference and thus hinder the learning
process.
• The distance between the two remote controls and the nearest light source
should be at least 1 metre.
• The learning process is terminated without saving if no button is pressed or
no signal is received for 30 sec. while learning mode is activated.
• In learning mode, each button can only be assigned one function. A new
function overwrites the function previously taught on this button.
• The TV, DVD, STB, SOUND, AUX, DVBT and SETUP buttons cannot be
assigned new functions.
6in1
ORIGINAL
ca. 3 cm
9