Hama 00040074 Bedienungsanleitung Seite 10

6.2 Volume Punch Through / Volume Lock and Unlock
With the volume punch-through function, the [Vol+] or [Vol-], [MUTE] commands can
bypass the currently controlled device and change the volume of a second device. All
other commands are unaffected.
Note
• On some devices, the [Vol+], [Vol-] and [MUTE] buttons have no function. In
this case, the remote control automatically forwards the commands to the
programmed TV.
6.2.1 Transfer volume control - Volume lock
• Press and hold the [SETUP] button for approx. 3 sec. until the status LED lights
up continuously.
• Use the corresponding device button (e.g. [TV]) to select the desired device
to which the volume control is to be transferred. A successful selection is
con rmed by the status LED ashing once and then lighting up continuously.
• Press the [MUTE] button. The LED ashes once and then lights up permanently.
• Press the [Vol+] button. The setting is activated when the status LED ashes
3 times and then goes out. The [Vol+], [Vol-] and [MUTE ] buttons were
successfully transferred.
6.2.2 Unlock volume control - Volume unlock
• Press and hold the [SETUP] button for approx. 3 sec. until the status LED lights
up continuously.
• Use the corresponding device button ( e.g. [TV] ) to select the device to which
the volume control has been transferred. A successful selection is con rmed by
the status LED ashing once and then lighting up continuously.
• Press the [MUTE] button. The LED ashes once and then lights up permanently.
• Press the [Vol-] button. The setting is deactivated when the status LED ashes
3 times and then goes out. The [Vol+], [Vol-] and [MUTE ] buttons have been
successfully unlocked.
Note
• This function is deactivated in the factory settings.
6.3 Macro Power
Macro Power allows you to switch two AV devices on/off simultaneously.
6.3.1 To activate the Macro Power function:
• Press and hold the [MUTE] and [Vol+] buttons simultaneously for approx. 3
sec. until the status LED lights up continuously.
• Use the device button to select the device to be operated (e.g. [TV]). A
successful selection is indicated by the status LED ashing once and then
lighting up continuously.
• Enter the code [9] [5] [0], the status LED ashes 2 times and then lights up
permanently.
• Use the device button to select the second device to be operated (e.g. [STB])
which is to be switched on in the future. A successful selection is indicated by
the status LED ashing once and then lighting up continuously.
• Press the [OK] button. The setting has been successfully activated when the
status LED ashes 3 times and then goes out.
8