Mounting The Appliance - Atag KS1088C Einbauanweisung

· Push the appliance 38 mm into the kitchen unit
and allow at least 4 mm free space on both sides
between the appliance and the side walls of the
kitchen unit (Fig. 1).
· Widely open the door and put it together with the
kitchen unit door. The procedure is as follows.
- Fix the slide guides (attached in a plastic bag along
with the screws ST 4,2 x 9,5) to the edge of the
door. Cover the open holes with the attached cap
- Put together the appliance door and the door of
the kitchen unit (Fig. 2).
- Insert the slides into the guides and fix them on
the kitchen unit door 15 mm from the edge, using
the A 4 x 12 screws (Fig. 3).
- Remove the slide guides and separate the
appliance door from the door of the kitchen unit.
- Fix the slides and be careful not to move them
while fixing (Fig. 4).
- Fix the slide guides to the original position.
- Close the door and check the gasket (it should
not be damaged). The door should open and close
smoothly.
NOTE:
Appliance with the height of 575 mm have only one
slide and one slide guide.
· Fix the appliance into the kitchen unit. On the upper
side, fix the three screws through the rail (A 4 x 12)
and on the bottom side with two screws, through
the lower hinges (A 4 x 16). Drill holes, ø 3 x 5
(Fig. 5).
· Seal the gap on the opposite side of the hinge with
the enclosed strip (Fig. 6).
WARNING
Before mounting the appliance into the kitchen unit,
disconnect the power supply and set the thermostat
knob to STOP position or switch off the ON/OFF
switch.
mounting instructions

mounting the appliance

25