OHAUS Scout Serie Bedienungsanleitung Seite 7

TM
SCOUT SERIES BALANCES - SPX
1
2
3
4
5
6
Item Description
1 Battery charge symbol
2 Stable weight symbol
3 Negative symbol
4 Center of Zero symbol
5 NET symbol
6 Preset Tare symbol
7 Pointer symbols
Note: * Some symbols might not be available depending on different models.
3.2 Turning Balance On/Off
To turn the balance on, press and hold the On/Zero Off button for 1 second. The balance
performs a display test, momentarily displays the software version, and then enters the active
weighing mode.
To turn the balance off, press and hold the On/Zero Off button until OFF is displayed.
3.3 Calibration Operation
When the balance is operated for the first time, a span calibration is recommended to ensure
accurate weighing results. Before performing the calibration, be sure to have the appropriate
calibration weights. Ensure that the Security switch is set to unlocked position.
Press and hold Menu until [
will show [
calibration.
[ ] will be displayed while zero reading is stored. Next, the display shows the calibration
weight value (press No to toggle value). Place the specified calibration mass on the pan. [
will be displayed while the reading is stored. The display will show [
successful. The balance returns to the previous application mode and is ready for use.
Find Quality Products Online at:
7
Figure 3-1. Scout Display
TABLE 3-2. Display Symbols*
] (Menu) is displayed. When the button is released, the display
]. Press Yes to accept. [
GlobalTestSupply
www.
Item Description
8 Kilogram, grain symbols
9 Check Weighing symbols
10 Pound, Ounce, Pound:Ounce symbols
11 Percent, dwt, g/mol symbols
12 Gravity, Pieces, t hk, t sg, t tw, Hold
symbols
13 Newton, Totalization, Dynamic, Bluetooth
symbols
] will then be shown. Press Yes to begin the span
.com
EN-5
13
12
11
10
9
8
] if the calibration was
sales@GlobalTestSupply.com
]