Atag HI9071M Anleitung Seite 124

general information
pans
attention
noise in the base of the pan
pressure cookers
GB 10
Once you remove the saucepan from the hob, the cooking
activity stops automatically. However, you should get used to
always switching the hob or zone off after use in order to
avoid the hob or zone being switched on unintentionally.
Be careful with enamelled sheet-steel pans. These can be
damaged if they are used for induction cooking, particularly if
their bases are too thin.
With enamelled sheet-steel pans:
• the enamel may chip (the enamel comes loose from the
steel), if you switch the hob on at a high setting when the
pan is (too) dry;
• the base of the pan may warp - due, for example, to
overheating or to the use of too high a power level.
Never use pans with a misshapen base. A hollow or rounded
base can interfere with the operation of the overheating
protection, so that the appliance becomes too hot. This may
lead to the glass top cracking and the pan base melting.
Damage arising from the use of unsuitable pans or from
boiling dry is excluded from the guarantee.
While cooking, you will be able to hear a rattling noise in the
base of the pan. This is harmless. The noise is due to the
high power of the cooking zone having an effect on the base
of the pan.
Reduce the rattling noise by selecting a lower setting.
Induction cooking is very suitable for cooking in pressure
cookers. The cooking zone reacts very quickly, and so the
pressure cooker is quickly up to pressure. As soon as you
switch a cooking zone off, the cooking process stops
immediately.