Charging Batteries - Team Orion ADVANTAGE ONE 406 Bedienungsanleitung

Battery capacity
WARNING! Improperly adjusting the battery
a
capacity setting can overload the battery and result
in fire, property damage or injury!
Adjust this setting to the battery capacity value in mAh
(milliamp hour). The charger uses this setting to automati-
cally adjust the charge current to an optimal value of 1C
(equal to the battery capacity).
NOTE: as a safety measure, when charging NiMH/NiCd
batteries, the charge will stop when the charged mAh
counter reaches the preset value (whether the battery is
actually full or not).
Charge current
WARNING! Using a charge current, which is
a
too high, can overload the battery and result in
fire, property damage or injury! Always follow the
battery manufacturer recommendations.
The charger automatically adjusts the charge current in
relation to the battery capacity setting (see above), but
you can also adjust the charge current by yourself. The
charge current is adjustable in 0.1A steps up to 6A. The
standard charge current is 1C, which means one time
the battery capacity, ex. 4000mAh battery = 4A charge
current. A higher charge current charges the battery faster.
NOTE : depending on the battery type, the actual charge
current may be lower than the charge current setting.
12 - English

CHARGING BATTERIES

WARNING! Always use charge settings which are
a
compatible with the battery. Always use only com-
patible connectors. Always monitor the charging
process. Always disconnect the battery from the
charger once the charge is finished. Always end
the charging process if the battery becomes hot to
the touch or starts to change form (swell) during
the charge process. Failure to carefully setup the
charger and monitor the charge process can result
in fire, property damage or injury!
Battery connector : one charge lead with one battery
connector type is supplied with the charger (Deans or
EC3, depending on the version). If your battery uses a
different type of connector, you will have to purchase a
compatible charge lead or adapter separately.
Adapter : a Deans to Tamiya adapter is also included with
certain versions of the charger. This allows you to charge
batteries equipped with Tamiya connectors by connecting
the adapter between the battery and charge lead.
Safety timer : The charger features a 120 minutes safety
timer. This means that after 120 minutes the charge will
stop whether the battery is fully charged or not. Depending
on the battery type you are charging, you may have to
restart the charge to achieve a full charge of the battery.
YOU CAN STOP THE CHARGE PROCESS AT ANY
TIME BY PRESSING THE ENTER/STOP KEY.
Team Orion Advantage ONE 406