Charging The Battery - Team Orion Advantage Race Spec Anleitung

Charging the battery

While charging NiMH/NiCd batteries, the charge might be interrupted before the battery is fully charged
(battery should be slightly warm to the touch if it is charged). If this is the case you may restart the
charge process again or try using a higher delta-peak value.
With LiPo or LiFe batteries, if the voltage is too low, the charger will perform a slow charge to increase
the voltage of the cells inside the battery before starting the fast charge. Cell balancing will only take
place at the end of the fast charge; cell balancing can take a long time to complete if the level of
unbalance is high. While balancing, the charger will display the „LIPO BALANCE" message.
Note: Depending on the conditions of use, the charger thermal protection might activate so that
the charger can cool down. After a brief interruption the charge will resume and continue normally.
16
After you have selected the right parameters and con-
nected the battery, press and hold the ENTER key. The
battery check will be displayed.
If the battery is properly connected and functional the
charge screen will be displayed.
Team Orion Advantage Race Spec
The charge will be interrupted when anyone of these conditions is met:
• the automatic delta-peak cut-off system activates
• the charged capacity reaches the preset value (for NiMH/NiCd)
• the charger software has determined that the LiPo/LiFe battery is full.
At the end of the charge cycle,
the "BATTERY CHARGE COMPLETE" message will appear.
Press the ENTER key to display the final charge data, indicating the total charge time, total charged
capacity (in mAh), the battery's peak voltage (for NiMH/NiCd) and the battery's final voltage.
Charge end data LiPo/LiFe
Press the BATT TYPE key to display the battery internal resistance or individual cell voltage (only for
LiPo/LiFe with balancing connector). Press the ENTER key to go back to the charge screen
www.teamorion.com
Charge end data NiMH/NiCd
17