Charger Setup - Team Orion ADVANTAGE ONE 406 Bedienungsanleitung

CHARGER SETUP

WARNING! Always identify the battery type and
a
make sure that it is compatible with the charger!
Always use charge settings, which are compatible
with your battery! Failure to use appropriate charge
settings or attempting to charge an incompatible
battery could result in fire, property damage or
injury!
You must use and setup the charger according to the
battery manufacturer's recommendations; make sure that
you properly identify the battery type and specifications
(usually indicated on the battery label). The charger can
charge NiMH/NiCd batteries from 1 to 10 cells and LiPo/
LiFe batteries with 2 to 4 cells.
Modifying the charge settings
To modify the charge settings, press the ENTER/STOP
key to enter setup mode. Press the ENTER/STOP key
to switch between the available settings (the settings will
flash when selected). Use the + and – keys to change the
value of the settings.
You can exit the setup mode by pressing the SET/MODE
key.
Settings memory
The charger has 10 memory slots for saving charge set-
tings. The settings are automatically loaded as you cycle
www.teamorion.com
through the memory slots and automatically saved to the
current memory slot as you modify them. Memory slots 1
to 5 are only for LiPo/LiFe batteries settings and 6 to
10 are only for NiMH/NiCd batteries settings.
Battery type
WARNING! Selecting the wrong battery type when
a
charging your battery could result in fire, property
damage or injury!
The charger can charge NiMH, NiCd, LiPo and LiFe
batteries. Select the correct battery type for the battery
you wish to charge.
The different battery types use specific charging methods;
make sure you select the correct battery type to avoid
accidents.
Number of cells
WARNING! Improperly adjusting the number of
a
cells selected could result in fire, property damage
or injury!
Batteries are usually composed of two or more cells, adjust
this setting to the number of cells contained inside the
battery (LiFe = 3.3V/cell, LiPo=3.7V/cell, NiMH-NiCd=1.2V
cell). The charger can charge LiPo/LiFe batteries with 2
to 4 cells (6.6-14.8V) and NiMH/NiCd batteries with 1 to
10 cells (1.2-12V).
English - 11