Atag CM4411AC Anleitung Seite 130

MAINTENANCE
B
C
D
EN 22
5. Carefully clean the inside of the machine. Scrape off the encrusted
coffee in the coffee machine using a wooden or plastic fork or
something similar that will not scratch the fi nish (fi g. 26).
26
6. Remove all the remains with a vacuum cleaner (fi g. 27).
27
7. Replace the brewing unit (A) by pushing it into the holder (B) and the
A
pin (C). The pin must be introduced into the tube (D) at the bottom
E
of the brewing unit. Now push fi rmly where it says PUSH (E) until the
brewing unit is heard fastening into place (fi g. 28).
28
8. Once you have heard the unit clicking into position, make sure that
the red buttons have snapped back out, otherwise the service door
cannot be closed.
• The two red buttons are correctly snapped out (fi g. 29).
• The two red buttons are not snapped out (fi g. 30).
29