Manual Instruction; Important Safety Instructions; Operating Instructions - Optimum CJS-4011 Bedienungsanleitung

To avoid damage or hazards as a result of improper use, read
this instruction manual carefully before operating the appliance.
Take care to follow the safety instructions at all Times.

ImPORTANT SAFETY INSTRUCTIONS

• This appliance is designed for domestic use only and not
for commercial applications. No responsibility is accepted
for damage resulting from improper use or noncompliance
compliance with the instructions.
• Please keep these instructions for future reference. If the
appliance is passed to another person, this instruction
manual should accompany it.
• Before inserting the mains plug into the socket, check that
the mains supply voltage and current rating corresponds
with the power supply details shown on the appliance model
label.
• Never allow the base or the kettle to make contact with or be
immersed in water. However, should this happen, have the
unit examined by a qualified service centre before using it
again.
• In order to comply with safety regulations and to avoid
hazards, repairs of electrical appliances must be carried out
by qualified personnel, including the replacement of the
power cord.
If repairs are needed, please send the appliance to our
customer service department.
• Do not operate the appliance if
– the appliance or power cord show any signs of damage,
– the appliance has been dropped.
• Always remove the plug from the wall socket
– after use
– in case of any malfunction,
– before cleaning.
• When removing the plug from the wall socket, never pull
on the power cord.
• Children do not recognise that may occur when operating
electrical appliances. Therefore keep children away from
such appliances.
• Do not attempt to remove any parts of the housing nor insert
any metal objects into the interior of the appliance.
• To prevent damage to the power cord, do not let it pass over
sharp corners or edges.
• Do not position the appliance or power cord on or near hot
surfaces (such as oven plates) or near open flames.
• Do not expose the appliance to rain or moisture and do not
operate the appliance outdoors or with wet hands.
• The appliance operates at very high temperatures, Caution:
there is danger of scalding form escaping water or steam.
Do not touch any part of the kettle except the handle when
Cordless Kettle
CJS-4011 / CJS-4012

MANUAL INSTRUCTION

the appliance is in use and ensure that the lid is properly
closed.
• This appliance is designed for heating water only. Never put
any other liquid into the kettle.
• When using the appliance, always pay attention to the
water level marking on the outside of the kettle. Do not let
the water level drop below the minimum level and do not
exceed the maximum level.
• Always place the appliance on a firm and level surface.
• If the supply cord is damaged, is must be replaced by
the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
• This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not
play with the appliance.
• If the kettle is overfilled, boiling water may be ejected.
• Warning: Do not remove the lid while the water is boiling.
• The kettle is only to be used with the stand provided.
• The appliance must not be immersed.
OPERATION GUIDELINES
Before using for the first time
• Prior to initial use, clean it by going through several boiling
cycles, using clean water with each cycle and filling the
kettle to its upper marking.
Operation
• Place the heating base on a firm and level surface.
• Pour the desired amount of clean water into the kettle.
• Position the kettle in such a way on the base that the
underside of the kettle fits precisely into the contact unit on
the base.
• Insert the plug into a wall socket.
• To start boiling press the ON/OFF switch to the down
position.
The power indicator will illuminate and the kettle will start
to boil. NEVER REMOVE THE LID DURING BOILING.
• When the water has boiled the kettle will switch off
automatically and the power indicator will extinguish.
• You can stop the boiling process at any time by pressing the
switch to the OFF position.
• After the kettle has switched off automatically, there may be
a short delay before it can be re-boiled. This is usually no
more than 20 seconds.
UK
5