Abus FUBE50000 Installations- Und Bedienungsanleitung Seite 37

Start-up
as well as how frequently they are being carried out via the control panel. The length of
battery life when operating without an external power supply and under the following
conditions is roughly one year: arming 3x daily, disarming 3x daily, Prox calibration once
daily (automatic process), no exit time programmed.
LED test/software version display
If the tamper contact is open when the control device starts up, the following
LED test will be performed and the software version displayed.
(1.) All four status LEDs (sub-areas 1 to 4) flash red to confirm that they are
working.
The software version of the control device is displayed in sequence by the
red "RF TX" and the green "TEST" LED. Both LEDs are located on the PCB
close to the DIP switch.
(2.) The red transmitting LED (RF TX) indicates the major software version.
(3.) The green test LED (TEST) indicates the minor software version.
Installation and start-up
7. Insert the three AA alkaline batteries in the
battery compartment.
Make sure the polarity is correct.
As a rule, if it is possible, an external power
supply should be used. In this case, the
batteries act as a reserve power supply. If an
external power supply is not possible, the
control panel can also be used with certain
concessions in battery mode. The actual
battery life is, in this case, largely dependant
on the functions being carried out (Prox
reader, key pad lighting)
EN 13