Abus FUBE50000 Installations- Und Bedienungsanleitung Seite 36

Installation and start-up
DIP switch layout
6. Adjust the DIP switch as required.
Factory/defa
Function
ult setting*
1
2
3
4
5
6
7
8
 The "Permanent Status LEDs", "Permanent Key Lighting" and "Info and Alarm Tone
Sounds on the control device" functions are only available during operation with an
external power supply.
 For the "Info and Alarm Tone Sounds on the Control Device" and "Permanent Status
LEDs" functions, "Broadcast Panel Status" must be activated on the alarm panel.
 For the "Info and Alarm Tone Sounds on the Control Device" function, the
"Permanent Status LEDs" function must also be switched to ON.
 In order to use the chip key function, we recommend using an external 12 V power
supply. Although the use of this function is possible without an external power supply,
this will make chip key recognition slower and will shorten the wireless control device's
battery life.
12 EN
Permanent status LEDs
Backward compatibility
Battery operation
Info and alarm tones on
the control device
Keypad tones
Chip key reader
Permanent keypad
lighting
Unused
OFF
The status of the sub-
areas is only displayed for
a few seconds during
operation*
FUAA50xxx*
Power supply unit
operation
(incl. batteries)*
No info or alarm tones on
the control device*
Keypad tones deactivated*
Chip key reader
deactivated
Keypad lighting during
operation only*
(times out after 15 s)
-
ON
Permanent status LEDs
FU80xx
Battery operation
(without power supply unit)
Suppresses the status
message "Ext. PSU error"
on the alarm control panel
Info and alarm tones on
the control device*
Keypad tones activated*
Chip key reader activated*
Permanent keypad lighting
-