Electrical Installation - Respekta CH 11050 ISB Montageanleitung

English
Observe the safety distance between the hob and hood. (Chapter 11.1 in the user's
manual)
The ceiling must can bear at least 120KGs weight, and the thickness of the ceiling must be
≥30MM.
Electrical Installation
All the installation must be carried out by a qualified electrician. Before connecting the
mains supply ensure that the mains voltage corresponds to the voltage on the rating plate.
Direct power connection.
The appliance must be connected directly to the mains using
an omnipolar circuit breaker with a minimum opening of 3mm
between the contacts.
The installer must ensure that the correct electrical
connection has been made and that it complies with the
wiring diagram.
The cable must not be bent or compressed.
Regularly check the power plug and power cord for
damage.If the supply cord is damaged, it must be replaced
by a special cord or assembly available from the
manufacturer or its service agent.
This appliance is supplied with a 3 core mains cable witout plug, coloured as follows:
L = Live
N= Neutral
=Earth
For safety reasons, only use the mounting parts and fastening screws of the same
size recommended in this inastallation manual.
Failure to install the screws or fixing device in accordance with these instructions
may result in electrical hazards.
fi200604atl
Installation Instruction
brown
blue
yellow/green
2
Modells:
CH 11050 ISB
CH 11050 IWB
GB