Honeywell HJ Serie Benutzerhandbuch Seite 4

SAFETY (CONTINUED)
• Place the machine in a flat and dry place and keep a
distance of above 50cm between the machine and the
surrounding objects or walls.
• After the air conditioning is installed, ensure that the power
plug is intact and firmly plugged into the power outlet,
and place the power cord orderly to prevent someone from
being tripped or pulling out the plug.
• When drainage pipes are installed, ensure that the drainage
pipes are properly connected, and are not distorted or
bended.
While adjusting the upper and lower wind-guide strips of
the air outlet, pluck it with hands gently to avoid damaging
wind-guide strips .
• The appliance should be transported upright or on its side.
• DO NOT use the device in the following cases:
- in a room with continously operating sources of ignition
(eg. open flames, an operating gas appliance or an
operating electrical heaters.
- In areas where gasoline, sulphur, oil, paint or other
flammable goods are stored.
- In an area where the water can be projected.
• DO NOT touch the plug or the device with wet hands.
•
Flammable substances or pressurized containers (eg.
aerosol cans) should be kept a minimum of 50cms away.
• Do not turn on the appliance for at least one hour before
starting it.
• DO NOT operate the unit with a damaged plug or loose wall
outlet. If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
EN