ZAMEL VP-819B Betriebsanleitung Seite 45

ANSWERING AN ENTRANCE PANEL CALL
When a visitor presses the Call button on the entrance panel, all connected indoor displays
will sound the call chime at the same time as the INCOMING CALL message on each display
screen.
Touch the icon to answer the call. Touch
panel camera feed to all other displays. If the call is not answered by the time the call chime
stops, the display will enter the standby mode. Touch the
catch of the calling entrance panel during the call. The display will show DOOR OPEN.
Touch the icon to open the gate. The display will show GATE OPEN. If another user
calls during your call, the display will show VISITOR AT DOOR 2. Touch the
answer and switch to the second call.
Note: Touch and hold the icon during an entrance call or an internal call
(display-to-display intercom mode) to mute your microphone. The display will show MUTE.
Touch and hold again to unmute your microphone, which the display will confirm with
SPEAK. Operating a gate requires the NC06 gate control module in the system.
VIDEO FEED MONITORING
With the display on standby, touch
Touch again to switch to the next video feed.
The CCTV camera video feeds can only be monitored this way if the Port 4 status is Enabled
(see Table SYSTEM SETTINGS, item 10).
Touch to start a voice call with the visitor at the entrance panel from which you are
monitoring the video feed. Touch
When monitoring the video feed from Door1/Door2/Video1/Video2, touch and hold
change the screen aspect from 16:9 to 4:3.
PUBLIC ADDRESS MODE
The Public Address mode allows you to speak through all displays connected to the video
entry phone system. When the display is on standby, touch and hold
The PUBLIC ADDRESS CALL message will be displayed.
again to send the calling entrance
icon to release the electric
to monitor the video feed from entrance panel no. 1.
to unlock the door of the same entrance panel.
icon to
to
on the screen.