Safety Instructions For The Use Of The Product; Particular Types Of Dangers; Maintenance, Service And Troubleshooting - ABNOX XFP-Slim-Serie Originalbetriebsanleitung

Safety Instructions for the Use of the
Product
All parts and assembly groups have been developed
and constructed in accord with the recognised rules
of safety engineering. However, if it is handled or
operated improperly, this can result in dangers to the
user or third parties or hazards to the product or to
their property.
The product must only be used:
• For its intended purposes.
• In a proper condition in terms of its safety
engineering features.

Particular Types of Dangers

Elektrische Energie
ELECTRICAL VOLTAGE
Warning about electrical hazards
that can lead to bodily injury and/or
property damage.
Hydraulic and Pneumatic Energy
HYDRAULIC AND
PNEUMATIC SYSTEMS
Warning about hydraulic and
pneumatic hazards that can
lead to bodily injury and/or
property damage.
Hazards from hydraulic and pneumatic energy
The product works, depending on configuration, with
high hydraulic and pneumatic pressure (see technical
information). System sections such as pressure lines,
valves or consumers that must be opened must first
be depressurised before the start of repairs. There
may be no residual pressure.
Hazards from lubricants
The safety instructions form the lubricant manufac-
turer must be heeded and its instructions strictly follo-
wed. The manufacturer of this product rejects any
liability for incidents that result from failure to follow
the rules, instructions and recommendations of the
lubricant manufacturer.
Maintenance, Service and
Troubleshooting
• Prescribed calibration and maintenance work follo-
wing the maintenance schedule must be completed
in a timely fashion.
• Inform the operating personnel prior to any calibra-
tion or maintenance work.
• Turn off the main switch (if there is one).
• Disconnect the energy supply from the main net-
work and secure against unintentional reactivation.
• Pneumatic and/ or hydraulic systems must be
de-pressurised.
• Check all screw connections and armatures for
proper fit.
• Once all work is completed check all safety equip-
ment and operational functions.
CAUTION
Any and all work on the product may
only be carried out when it is idle.
ENVIRONMENTAL HAZARDS
The various materials/liquids are to
be handled properly and separately
disposed of in compliance with the
applicable national regulations.
en
21