Closing/Starting A Batch And Existing Job; Internal Batch Editor - Opex Falcon+ Betriebsanleitung

4.3.14. Closing/Starting a Batch and Existing Job

When you have finished scanning items in a batch, press Stop to turn off the
motors. Select Close and select Yes, close Batch to the "Close Batch?"
prompt. Next, you can either select Go to start a new batch or select Exit to exit
the job run screen and return to the Main job select screen (see Figure 4-55).

4.3.15. Internal Batch Editor

There is an internal Batch Editor that was introduced in an earlier CertainScan
software version. It should not be confused with the robust, separate Batch
Edit application introduced with CertainScan 3.0. The internal editor is typically
used to recover batches after a crash. Refer to the "CertainScan Edit" software
manual for complete information regarding the new application.
Operation
Figure 4-55: Ending the Job
Falcon+ Operator Manual
OPEX Corporation
95