Ergonomics - Opex Falcon+ Betriebsanleitung

2.1.2. Ergonomics

As in any occupation which requires you to perform the same motion
repeatedly during the course of your work, it is important to consider how you
perform your task. Always use proper operating procedures when operating
the scanner. Follow the directions for using and adjusting your chair and
scanner. Using improper procedures can result in a potentially serious injury.
The Falcon+ scanner has been designed for safe operation by over 95% of the
user population. Operation by individuals with limited reach capability or who
cannot follow the suggestions listed should be avoided or limited in duration.
To reduce possible risks, we strongly urge you to follow these suggestions:
• Maintain an upright body posture. Avoid the tendency to slump in your
chair. The angle between your torso and thighs should always be close to
90 degrees.
• Adjust the seat height on your chair or the height of the scanner so that
your elbow is approximately even with the top of the work surface when
your arms are near your sides and your feet are flat on the floor.
• Adjust your chair position to allow your torso to touch the front edge of the
scanner work surface. Chairs with arm rests that prevent this body position
should not be used.
• If the touchscreen is used frequently during processing, adjust the screen's
position to minimize your reach movements to the frequently touched
areas.
• Your position should allow you to comfortably reach the frequent work pick-
up area(s) and the frequently touched areas of the screen without
extending either arm fully or changing your posture.
• Occasionally change the angle of your posture and, if possible, vary your
tasks to create short breaks from the most repetitive motions.
• If possible, avoid operating the machine for longer than a single 8-hour
shift.
While no suggestions can guarantee completely against work-related injuries,
you will certainly increase your comfort and safety while operating the Falcon+
if you put these suggestions into practice. The scanner has been designed with
you in mind. If it is operated correctly, you should find your work experience
comfortable and enjoyable.
16
Falcon+ Operator Manual
OPEX Corporation
Safety